NEBS Level 3 and ETSI Certified
This section lists some of the steps required to configure a Factory Integrated Model compliant with typically requested telecom carrirer NEBS and ETSI requirements. In addition to the worldwide compliance criteria applied to the commercial version of the product, all components listed in this document have been evaluated to the following criteria: SR-3580, Level 3, NEBS Criteria Levels
· GR-1089-CORE, EMC & Electrical Safety
· GR-63-CORE, Physical Protections
· GR-3108-CORE Outside Plant
· ETSI EN 300 386, Class A, EMC
· ETSI EN 300 019-2-1, Class 1.2, Storage
· ETSI EN 300 019-2-2, Class 2.3, Transportation
· ETSI EN 300 019-2-3, Class 3.1 & 3.1E, Stationiary Use at Weather protected locations
· ETSI 300 132, Power Suppply Interface to Telecom Equipment, -48VDC
· ETSI ETS 300 753, Acoustic Noise
To ensure only valid configurations are ordered, Hewlett Packard Enterprise recommends the use of an HPE approved configurator. Contact your local sales representative for information on configurable product offerings and requirements.
Factory Integrated Models must start with a CTO Server. FIO indicates that this option is only available as a factory installable option. All Factory Integrated Models will be populated with sufficient hard drive blanks based on the number of initial hard drives ordered with the server. Some options may not be integrated at the factory. Contact your local sales representative for additional information.
Notes:
- To yield a carrier grade server that is compliant with all the required technical criteria, the product content is limited to what is listed in this document. In addition to this, the system maintenance switch #10 must be turned to the "ON" position to enable the expanded operating temperature range and hardware from the following kits MUST be installed:
o HPE ProLiant DL36X Gen10 Plus High Performance Fan Kit - P26477-B21
o HPE ProLiant DL360 Gen10 Plus High Performance Heat Sink Kit - P19368-B21
Please refer to the HPE DL365 Gen10 Plus Carrier Grade Conversion documentation on the HPE web site: http://www.hpe.com/services/hpsc
|